MIRA Elite Shower Switches with Thermal Cut‑Out Fuse – Pack of 2

MIRA Elite Shower Switches – Thermal Cut‑Out Fuse (Pack of 2)
Replace the safety switch in your Mira electric shower quickly and safely with this brand‑new, fully compatible set. Each switch comes with its own screw and washer for a secure fit, so you can get your shower back to full power without hassle.

Why it matters
The thermal cut‑out fuse protects you from overheating water by cutting power when the element temperature reaches 75 °C. Once the water cools below 48 °C the switch automatically resets, restoring heat without any manual reset needed. This essential safety component helps prevent scalds and prolongs the life of your shower.

Key features

• 2 × thermal cut‑out switches (right‑angle contacts) – compatible with Mira models post‑2012 and many other brands
• Includes fitting screw and washer for each unit
• On temperature: 48 °C | Off temperature: 75 °C (CKSD301C series)
• Designed for Elite, Go, Jump, Sport, Sprint, Vie and other Mira pumps (10.8 kW, 9.8 kW, 8.5 kW, etc.)

Installation tip – Always turn off the mains supply and have a qualified electrician perform the swap. Follow the simple step‑by‑step guide: remove the shower cover, disconnect the green earth wire and two brown wires, lift out the old switch, install the new one, reconnect wires and tighten all screws.

Compatibility note – This version has right‑angle contacts; if your shower uses diagonal contacts you’ll need part 416.41 instead.

Upgrade your shower’s safety today with a reliable MIRA Elite thermal cut‑out fuse set.